Home » Forums » Archived: Hardware

Case for EmonTX and temp sensor wiring

Submitted by Guest on Mon, 16/04/2012 - 20:18

Hi All

I have now successfully built my EmonTX and EmonBase units, loaded the code and have a working test setup with Pachube.  What i want to do know, is fit the EmonTX to a case. 

Will the EmonTX v2.0 fit the Farnell case as per v1.4? (MULTICOMP - BC2W - CASE, ABS, W/CLIP, WHITE)

Also i am after wiring up my encapsulated temperature sensor from the shop.  But i cannot find any reference to the wiring.

Would i be right in assuming GND = Black, Vcc = Red and Data = White?

Regards

Roger

 

‹ NanodeRF Ethernet problems, please help! - RESOLVED Vrms value ›
»
Drsdre's picture

Re: Case for EmonTX and temp sensor wiring

Submitted by Drsdre on Mon, 16/04/2012 - 23:06.

That's indeed the case that Glen mentions on his webshop pages (for example http://shop.openenergymonitor.com/emontx433-kit/ just above the documentation headline).

 

My EmonTX was fitted to a case from Dutch/German Conrad (article 522733). It did however require some additional filing of the PCB to make it fully fit (and of course cutting holes for all the plugs).

 

Regarding the wiring, I'm also curious what the scheme is.

»
logic's picture

Re: Case for EmonTX and temp sensor wiring

Submitted by logic on Tue, 17/04/2012 - 08:24.

For the temperature sensor wiring then:

Red - Vcc

Black - Gnd

White - Data

 

Taken from article - http://openenergymonitor.org/emon/node/530

 

Dennis

»
glyn.hudson's picture

Re: Case for EmonTX and temp sensor wiring

Submitted by glyn.hudson on Tue, 17/04/2012 - 10:18.

Wiring diagram for pulse and temperature sensor connections can be found here: http://openenergymonitor.org/emon/emontx/reference%20

»

Comment viewing options

Select your preferred way to display the comments and click "Save settings" to activate your changes.