Home » Forums » Archived: Software

Feed inactive - kWh to kWh/d

Submitted by Guest on Mon, 21/04/2014 - 06:22

Hello,

I use Emoncms online for a few week ... all work very fine !! Thanks for your good work !

So I have installed Emoncms of my Raspberry, the install work. I have Install the emoncms application via git.

The data Input is Ok but when I configure the process kWh to kWh/d, the feed is inactive and that after several hours.

Of my account online is work but the same configuration don't work of my Rapberry.

In check with Emoncms V8.0.8 and V8.1.2, I have the same problem. Can you help me ?

‹ RPi, EmonCMS - replace USB drive with network share (NFS or CIFS) Stuck at getting the Input Values into a display ›
»
gloorung's picture

Re: Feed inactive - kWh to kWh/d

Submitted by gloorung on Mon, 21/04/2014 - 18:49.

Could it be because redis is not installed? The kwh-to-kwh/d operator only works if this is installed.

»

Comment viewing options

Select your preferred way to display the comments and click "Save settings" to activate your changes.