Solved: New Installation - no feeds

Submitted by borpin123 on Sat, 25/01/2014 - 15:44

Brand new installation but the old emoncms as I have had this running for a while on the Pi without any sensor nodes.

I now have a V3 TX and a TH. The RPi page thinks the module is happy but no inputs magically appear from either node.

Help!

Submitted by ukmoose on Sat, 25/01/2014 - 16:32.

Have you checked the nodes are broadcasting any data?

All units must use the same frequency
All units must use the same networkGroup
Each unit must have its own Node_ID

Submitted by borpin123 on Sat, 25/01/2014 - 17:16.

Ho do I check if the nodes are broadcasting data?

All are same frequency.

Networkgroup? TX3 is prebuilt so expecting it is the same as the RPi and TH (prebuilt) but that may be an assumption.

Submitted by borpin123 on Sat, 25/01/2014 - 17:37.

Solved - Discovered somewhere that the default NetworkGroup should be 210 - it was 1 in Emoncms,

Archived Forum