Trying to get to up load the sketches to my fresh and new nanodo. The GLCD and the TX are working ,still have to work out why the shield only outputs on 3ct with the regular tx shield sketch but it works.
For the RF it is a different story. when I power it up the red led blinks 3 times and than the red and green flip flop. When I try to upload a sketch over the isp port I get the massage back something like: wrong microprocessor found check your board choice in option menu and
avrdude: Expected signature for ATMEGA328P is 1E 95 0F
Double check chip, or use -F to override this check.
Anybody experience with this issue before? Looking on the forum but could not find any answers.
Problem uploading sketch to NanodoRF
Submitted by ernst on Sun, 23/06/2013 - 17:47Newbee.
Trying to get to up load the sketches to my fresh and new nanodo. The GLCD and the TX are working ,still have to work out why the shield only outputs on 3ct with the regular tx shield sketch but it works.
For the RF it is a different story. when I power it up the red led blinks 3 times and than the red and green flip flop. When I try to upload a sketch over the isp port I get the massage back something like: wrong microprocessor found check your board choice in option menu and
avrdude: Expected signature for ATMEGA328P is 1E 95 0F
Double check chip, or use -F to override this check.
Anybody experience with this issue before? Looking on the forum but could not find any answers.