Home » Forums » Archived: Software

error: expected ',' or '...' before numeric constant (FIXED)

Submitted by Ian Eagland on Sat, 03/01/2015 - 15:29

Hi

I have just tried to recompile an old emontx lowpowertemperature sketch as I need to change the nodeID and I got the above error. I guess there has been a library change. Unfortunately the Arduino version (and libraries) that I used to compile the original sketch back in March 2013 has been uninstalled when I upgraded the Arduino software.

Can somebody suggest the best way to proceed. Should I try to find an older version of the jeelib library and replace on a temporary basis the version currently used, or should I try to find the cause of the error and change the code elsewhere.

Regards

Edit

Found later version of  master firmware that compiles without error.

 

Ian

 

 

‹ calcIrms - initialising sampleI event module not working for "reduces by" or "increases by" patterns ›
Robert Wall's picture

Re: error: expected ',' or '...' before numeric constant (FIXED)

Submitted by Robert Wall on Sat, 03/01/2015 - 17:31.

Ian, there's a sticky post at the top of this forum about exactly this problem.

»

Comment viewing options

Select your preferred way to display the comments and click "Save settings" to activate your changes.