Home » Forums » Archived: Hardware

Non-wireless connection

Submitted by rushed on Fri, 21/02/2014 - 15:55

Hi,

I've setup an emontx V2 - using an arduino shield from the shop. It's currently recording 3CT channels and AC voltage which it merrily spits out onto the arduino serial monitor.

My question is - can I get this data onto a Raspberry Pi (and then onto emoncms) through a wire rather than through RF? The Pi is sitting next to the Arduino and they're both right next to the router so using radio seems a bit crazy (and a bit of a waste of money).

 

I'm a beginner to both platforms so please be gentle!

 

Thanks

‹ Solar PV power diversion with emonTx V3 using a PLL and temperature measurement Arduino Shield Support ›
»
rushed's picture

Re: Non-wireless connection

Submitted by rushed on Fri, 21/02/2014 - 16:42.

Sorry,  should have dug deeper in the forum!

 

http://openenergymonitor.org/emon/node/3619

»
pb66's picture

Re: Non-wireless connection

Submitted by pb66 on Fri, 21/02/2014 - 16:57.

you should also take a look here http://openenergymonitor.org/emon/node/3872 same method will work a v2.

Paul

»

Comment viewing options

Select your preferred way to display the comments and click "Save settings" to activate your changes.