Hi,i m try upload test sketch on my GLCD (without any emonTX station and sensors) and get error
Template_Example.ino: In function 'void loop()':
Template_Example:49: error: 'draw_power_page' was not declared in this scope
Template_Example:52: error: 'draw_temperature_time_footer' was not declared in this scope
Template_Example:59: error: 'draw_power_page' was not declared in this scope
Template_Example:62: error: 'draw_temperature_time_footer' was not declared in this scope
Template_Example:69: error: 'draw_solar_page' was not declared in this scope
Arduino libraries exist in lib folder. But i can upload one of the examples GLCM_SSM. Arduino IDE 1.0.5 also i tryed 1.5.4 no results.Thanks
Re: cant upload sketch on EmonGLCD
When opening say the HomeEnergyMonitor.ino example it should load the other sub files at the same time (icons.ino and templates.ino) The error's you see there are related to the sketch needing the functions that are in the templates.ino page.
Do you have icons.ino and templates.ino in the same folder as in the standard emonglcd examples folder?
Re: cant upload sketch on EmonGLCD
Hi,Trystan. Yes, icons on it.Files exist. I try compile HomeEnergyMonitor.ino -its OK, but after i click compile and upload button in IDE and get error
avrdude: stk500_getsync(): not in sync: resp=0x00
Now i try reinstall IDE, drivers
No result!!! After reinstall IDE apper message about low memory
<tag> Sketch uses 24 344 bytes (75%) of program storage space. Maximum is 32 256 bytes.
Global variables use 1 645 bytes (80%) of dynamic memory, leaving 403 bytes for local variables. Maximum is 2 048 bytes.
Low memory available, stability problems may occur
avrdude: stk500_getsync(): not in sync: resp=0x00
</tag>
Question: could i insert another ATMega chip with UNO bootloader and try again or it uncompatible ?
Thanks
Re: cant upload sketch on EmonGLCD
Can the emonGLCD run a standard example sketch such as blink.ino?
If it can, that might be a useful stage to try - no libraries required.
Re: cant upload sketch on EmonGLCD
Thaks for reply.Standart Blink.ino sketch dont uploading either with stk500 error message. I remove ATmega chip and repalace with another from emonTX PCB, try install IDE on another PC and still get 500 error code.Please help, i use arduino USBtoSerial board to connect emons product with PC.
Re: cant upload sketch on EmonGLCD
After some experiments i saw that driver is OK cause i can upload blink etc on arduino UNO (another plate) and its work. Now i measure voltage between GRN and PWR and it become 5V , but it should be 3.3V isnt it? (it was 3.3 then i constructed it as describe in tutorial). Whats should i do? THX