Home » Forums » Archived: Hardware

directly connect emonbase ed emontx

Submitted by Guest on Tue, 09/07/2013 - 14:54

I purchased the nanode rf 433 and in the kit is arrived the emontx shield!
How do I use! I expected the standard ATMEL emontx .With which you can program! otherwise how do I program the emontxshield?

‹ EmonTX Low Power Temperature Node with DHT22 sensor Advantages of using the ATMega32U4 (Leonardo) chip for power measurement ›
»
Robert Wall's picture

Re: directly connect emonbase ed emontx

Submitted by Robert Wall on Tue, 09/07/2013 - 16:20.

If you ordered the wrong kit (and you have not soldered it), you might be able to negotiate with the shop to part-exchange it for the emonTx. The shield is only the hardware for the inputs and the radio module to plug in to an Arduino board. There is no processor, so you cannot program it. You program the Arduino itself.

»

Comment viewing options

Select your preferred way to display the comments and click "Save settings" to activate your changes.