Hi
I am using a PI as a remote server WITHOUT a RFM12BPi
Having had trouble with SD cards failing I decided to do a complete new install running the PI from a USB hard disk.
This was completed without any trouble following the instructions for debian here: http://emoncms.org/site/docs/installlinux.
I ignored the raspberry pi instructions as I assumed they are only if you use a RFM12Bpi.
I logged into the new emoncms without any problems. I recompiled my nanode firmware with the API key from the new emoncms.
However there are no inputs showing on the input page.
I am sure when I did my first installation the inputs just appeared. Have I missed something in the set up of the latest emoncms?
Regards
Ian
New emoncms install on Pi but No Inputs
Submitted by Ian Eagland on Thu, 18/04/2013 - 09:42Hi
I am using a PI as a remote server WITHOUT a RFM12BPi
Having had trouble with SD cards failing I decided to do a complete new install running the PI from a USB hard disk.
This was completed without any trouble following the instructions for debian here: http://emoncms.org/site/docs/installlinux.
I ignored the raspberry pi instructions as I assumed they are only if you use a RFM12Bpi.
I logged into the new emoncms without any problems. I recompiled my nanode firmware with the API key from the new emoncms.
However there are no inputs showing on the input page.
I am sure when I did my first installation the inputs just appeared. Have I missed something in the set up of the latest emoncms?
Regards
Ian