Hello all ! Running the emonTX-shield wich at the serial-monitor present the following: emonTx Shield CT1234 Voltage 3 Phase example Using RFM69CW Radio OpenEnergyMonitor.org Node: 11 Freq: 868MHz Network: 210 Voltage: 227.42 Phase 1: 0.13 A, -0.83 W, 29.35 VA, PF=-0.028 Phase 2: 0.12 A, -0.34 W, 27.34 VA, PF=-0.013 Phase 3: 0.11 A, 1.26 W, 24.76 VA, PF=0.051 Input 4: 0.17 A, 1.96 W, 39.70 VA, PF=0.049 And at the receiving end (radio-via works! There I managed to find what changes needed to be done): HomeEnergyMonitor.ino/icons.ino/templates.ino As a non-programmer/softwarewriting-illiterate, what to change for having the last 5 rows to present themselves at the emonGLCD ? cordially / C.
»
Re: emonGLCD and formatting what's presented
There is some documentation for the GLCD software on GitHub: https://github.com/openenergymonitor/EmonGLCD/blob/master/SolarPV/SolarP...
While the sketch described is not the one you are looking at, there should be enough information there to allow you to construct at least a simple single-page display showing the quantities that you desire.