I have got a feed logging realtime produced energy of a heat pump.
This feed show values below zero at times ( defrost cycle ).
In the dasboard, i want to filter these negative values from the dial.
It's possible to specify a Max. value, but not a min value.
Can i do this in any way? or do i need to create a new feed for this dial only, logging only positive data??
Re: Dashboard dial min value
Hi Bart,
The emoncms "allow positive" parameter will enable you to log only positive data. It's on the same menu you chose "log to feed" from. After you add it to the process list, move it to the position in the process list where you want to filter out the negative values.
Re: Dashboard dial min value
Bill,
I know about the filter but the problem is i need the negative data for the calculations, i just don't want to show them.
So basically i have to log to a new feed just to only show positive data?
Thx,
Bart
Re: Dashboard dial min value
So basically i have to log to a new feed just to only show positive data?
That would work.