Submitted by wattsupdoc on Sat, 10/10/2015 - 22:46
Emonpi received in California. Great looking piece of equipment.
I setup emonpi with one CT and US AC-AC wave monitor, no wifi.
Created account and logged into emoncms with Ethernet direct from MacAir.
All nodes show inactive, but CT is showing power in watts and changes with variations in load and wave monitor reports voltage (although incorrect at this time, since I have not yet scaled for US mains).
Created a feed, which shows correct value compared to CT node.
No data appears to be logging.
I read thread 10771, especially post by hrant on 06/06/2015 and verified lines in my emonhub config editor for node 5 match those of post by hrant.
I have power cycled emonpi several times with no change.
EmonPi inactive
Submitted by wattsupdoc on Sat, 10/10/2015 - 22:46Emonpi received in California. Great looking piece of equipment.
I setup emonpi with one CT and US AC-AC wave monitor, no wifi.
Created account and logged into emoncms with Ethernet direct from MacAir.
All nodes show inactive, but CT is showing power in watts and changes with variations in load and wave monitor reports voltage (although incorrect at this time, since I have not yet scaled for US mains).
Created a feed, which shows correct value compared to CT node.
No data appears to be logging.
I read thread 10771, especially post by hrant on 06/06/2015 and verified lines in my emonhub config editor for node 5 match those of post by hrant.
I have power cycled emonpi several times with no change.
Any guidance will be appreciated.
Regards