Home » Forums » Archived: Questions and support

U.S. EmonPi

Submitted by JBlackham on Sat, 01/08/2015 - 03:40

I have a PI that I have attached the RF Board to and I have installed the latest SD Card Image of the EmonPI on it.  I have an EmonTX and I am going to have that transmit to the EmonPI.  I live in the U.S. and I am unsure of what additional steps I need to take in settings this up.

‹ Solar Generation Power Question Unix time to human readable format? ›
»
Robert Wall's picture

Re: U.S. EmonPi

Submitted by Robert Wall on Sat, 01/08/2015 - 11:20.

You sound a bit mixed up there. EmonPi is a Raspberry Pi with a stripped-down (2 current inputs only) emonTx inside it. I think you have your Raspberry Pi as an emonBase (your setup is this?) on which you want to run the emonCMS software. Is that correct?

There's a Building Blocks page about using your emonTx in the USA, have you seen that?

»
JBlackham's picture

Re: U.S. EmonPi

Submitted by JBlackham on Sat, 01/08/2015 - 18:18.

EmonBase with EmonTX

»

Comment viewing options

Select your preferred way to display the comments and click "Save settings" to activate your changes.